UAE Oman India Kuwait
 
 
  Home About Us ParkerStore Events & News Careers Store Locator Contact Us
 
 
Print this page  
Remote I/O  
LB/FB System - Overview
Remote I/O for installation in zone 1 or 2
Modbus RTU
Profibus DP, DPV1
FDT, DTM Concept
HART Protocol via Profibus DPV1 or via service bus using standard softwares
Communication on copper or optic fiber
Standard RS485 segment, no Intrinsic Safety restrictions
Communication and power supply redundancy
Diagnostics and self monitoring
Configuration software available for FDT concept
Hot swapping
HCiR (Hot Configuration in Run)
Up to 192 digital signals and 96 analogue signals on the same bus address
Important references with main DCS and PLC
ATEX certification
Local Bus system  - Zone 2 or Safe area mounting
Plug-in modules on backplanes, Din rail mounting
Mounting in zone 2 or in safe area, in cabinets
Binary, analogue, RTD100, TC, voltage, frequency signals
24 Vdc power supply
Modules 2 to 8 channels for binary signals (single or multichannels modules)
Modules 1 to 4 channels for analogue signals
Output and input signals can be mixed on the same backplane
Up to 92 analogue signals and 184 digital signals on the same remote I/O station
IS and Non IS interfaces available
LED status indication
Field Bus System  - Zone 1 mounting
Plug-in modules installed in field housing IP66 certified
Intelligent combination of hazardous area protection methods
Encapsulated modules for rough environment
Installation in zone 1 in polyester or stainless steel housing
Binary, analogue, RTD100, TC, voltage, frequency signals
24 Vdc, 110 Vac and 230 Vac power supplies
Modules 2 to 8 channels for binary signals (single or multichannels modules)
Modules 1 to 4 channels for analogue signals
Up to 96 analogue signals and 192 digital signals on the same remote I/O station
Interfaces for Eex d devices
Eex i et Eex e can be mixed on the same unit
No hot work permit required for maintenance
PDF   Contact